How To: Mixing | Degassing | Basic Coloring | Coloring Techniques | Advanced

Alien Oral Violator

Designed for a friend, this devilish little alien prober has an evil secret. The head is made of soft, squishy silicone, and is designed to mushroom at the back of the throat for extra drooling with your oral violation. Ring base for most strapon harnesses and optional high-capacity squirting cum tube makes this a complete, well-rounded oral violation experience!

Buy Now

Instructions

Download - Print - Pour - Enjoy


I designed this toy for a friend with some very...unusual tastes. It's an alien oral violator carefully designed for maximum violation, with a high-capacity cum tube to add to the feeling of being utterly overwhelmed. Surrender to this alien intrusion and let it take you away!

The head is angled and made of very soft silicone, much softer than the body, so it squashes against the back of your throat to promote mximum discomfort. The cum tube is large for high volume, and it can be used with a suction cup or as a strap-on. The textured shaft helps provoke extra drooling.

The mold has four parts: the tip, the base that creates the suction cup, and the two parts for the shaft. I recommend printing the mold vertically with the base down. Make sure you print with support (I neglected to do this with the prototype, as you can see from the pictures.)

This model has two versions: one with a high-capacity (5mm inside diameter/7mm outside diameter) cum tube, and one without.

Both versions have four parts: the tip, the base that creates the suction cup, and the two parts for the shaft. I recommend printing the mold vertically with the base down. Make sure you print with support (I neglected to do this with the prototype, as you can see from the pictures.)

If you're making the cum tube version: Start by fitting one end of a 5mm inside diameter/7mm outside diameter food-grade silicone tube over the pin in the tip mold. Then fill the tip mold with soft (Shore hardness 00-20) silicone.

Once the silicone cures, place the two halves of the body mold over the tip. Thread the silicone tube up through the center of the mold, so it does not touch the sides, and out through the hole in the side. The hole in the side allows the silicone tube to exit the base without interfering with the suction cup and without pinching if you decide to use the oral violator with a strapon harness.

Mix, color, and vacuum some firm (Dragon Skin 20) silicone. Fill the mold to the brim, then carefully press the suction cup into the top. When the silicone cures, remove the suction cup mold first, then pry apart the body mold, then remove the tip.

 

To use, fill a 150ml catheter-tip syringe with your fluid of choice, and fit the other end of the tube over the end of the syringe for that authentic excessive-fluid hentai experience.

 

What You’ll Need

Optional

License

By downloading mold files from this site, you agree to the following terms:

The mold files and sex toy designs are protected by copyright. You may use the files to print a mold on a 3D printer. You may use the molds to cast sex toys for your own personal use, You may not:

  • Sell, give away, or otherwise transfer the mold files to anyone else
  • Use the molds to make sex toys for sale to others
  • Use the molds to make sex toys to give away to others in combination with sale of another product
  • Reverse engineer the sex toy designs for sale, or to create derivative molds or designs for sale
Basically, don't be a dick. Don't try to make money from the work I did. If you like these designs and you want to sell them or adapt them for sale, contact me! We'll work something out.